Individual protection
clothes shoes

Waterproof work jacket

For cold and rainy season!

Protection against rain UNI EN 343/2008: levels of requirements

This standard determines the requirements of materials and seams of clothing that protect against inclement weather such as rain, snow, fog and soil moisture. The garments are designed and manufactured with impervious and breathable materials and special care is taken in welding seams to ensure optimum comfort.
x = class of impermeability of the garment (class 1 to 3)
y = class of breathability of the garment (class 1 to 3)

The classes of protection resistance to the penetration of water (Wp):

Class 1 Wp = 8.000 Pa (as is)
Wp = 8.000 Pa (at the seams as is)
Class 2 Wp = 8.000 Pa (after pretreatment)
Wp = 8.000 Pa (at the seams, as is)
Class 3 Wp = 13,000 Pa (after pretreatment)
Wp = 13,000 Pa (at the seams, as is)

The classes of protection resistance to evaporation (Ret)

Class 1 Ret> 40 m2 Pa / W
Class 2 20 m2 Pa / W <Ret = 40 m2 Pa / W
Class 3 Ret = 20 m2 Pa / W

sort by :

Page 1 on 0 1

No product matches for your search

Page 1 on 0 1

Focus on

Information note on clothes

Manual

The garment is designed in accordance with the essential health and safety requirements laid down in Directive 89/686 / EEC notified in Legislative Decree no. 475/92, and the successive evolutions, in such a way as to comply with UNI EN ISO 13688: 2013, which governs work clothes.

The garment is designed in such a way that, under the intended conditions of use, it can offer adequate protection to the user and can be classified according to the second category Directive 89/686 / EEC and according to the product standard. through the services that result from the tests to which the prototypes were submitted.

These requirements are presented by a pictogram and its related indexes, they determine the requirements described by the standards to which the PPE conforms.

warnings

- The user must determine, by assessing the potential risks, the need to adapt the garment to other devices of body protection equipment.

- The performance of the garment is guaranteed if the correct size is chosen, and if it is worn and closed correctly.

- If the garment appears damaged or if a visual defect should be detected, suspend its use and replace it with a suitable garment.

- The Information Note must be kept for the duration of use of the PPE.

- No modification of the PPE is foreseen.

Limitations of use - the garment does not protect from:

- risk of clipping of movable inserts;

- risk of chemical projections (acids, solvents, etc.);

- risk of mechanical aggression (cutting, drilling, etc.);

- thermal hazards;

- risks of passing and extinguishing flames;

- risks of poor visibility;

- any other risk for which the garment is not certified.

Marking

The label (which measures 5.5 x 10.8 cm) bearing the CE mark will be integrated inside the garment. The writing, characters and pictograms are red on a black background, resistant to recommended cleaning cycles.

The dimensions of the characters are greater than 2 mm and the dimensions of the CE marking greater than 5 mm. The specific size of the garment will be on a separate label.

Are indicated:

1. manufacturer's logo;

2. the pictogram and the size table, indicating the standard category to which the clothing belongs;

3. the CE marking and the category of PPE;

4. the manufacturer's address.