The 3M disc is specially designed for trimming, stripping and stripping parquet floors . This parquet disc is suitable for all types of single-brush machines. 3M Scotch-Mesh Discs are thin, flexible discs made of a tough mesh fabric coated on both sides with graded abrasives and a tough resin. The range consists of different diameters and different grades (abrasive grain size).
The silicon carbide disc is composed of a professional-grade silicon carbide face glued to a heavy paper …
The parquet sanding disk consists of a trimming grid allowing to make a trimming of the parquet in severa…
Discs 3M special professional for trimming stripping setting parquet floors. Adaptable to all types of mo…
3M™ Scotch-Mesh™ Discs are designed for use with standard single-disc machines for the restoration of waxed or sealed wood floors. The discs are also used on marble floors for surfacing before crystallization or polishing with finer grits. Heavy-duty abrasive grains (silicon carbide) for more effective abrasion. Can be used dry on parquet floors or wet on stone floors.
The Janex disc comes in three sizes 330 mm, 406 mm and 432 mm. The performance of the Janex flush trim grid is: - Excellent wear resistance - Reusable disc - Chemical compatibility with acids, hydrocarbons, chlorinated derivatives, phosphates, surfactants - Wide variety of grains depending on the nature of the soil to be treated. The JANEX flush trimming grid disc is used: For the preparation of all types of parquet floors. Tip: Test the disc on a small area to avoid any damage to the floor being treated. The grain is available from 40 to 220 (40 / 60 / 80 / 100 / 120 / 150 / 180 / 220) The 40 being the most aggressive and the 220 the thinnest Each disc is marked with the grain to avoid confusion The silicon carbide disc is used: The Janex Silicon Carbide disc is used for heavy duty sanding of wood and parquet floors. It can also be recommended for stone, marble and concrete. Use with a standard machine up to a speed of 350 rpm. For maximum efficiency, use a speed of 150 rpm. Tip: Always test the disc on a small area to avoid any damage to the floor being treated. P16 grain is a coarse grain : it is used initially to remove the maximum amount of material by sanding. Then use the smaller P24 grain to be a little less aggressive and sand more finely
• Start with grain 60 (coarse) until the floorboards are level or the protection is completely removed. • Continue with 80 grit (medium) to soften the wood. • Finish with 120 grit (fine) to smooth before applying the protection. • Dust the entire surface thoroughly. • Apply the first protective coat and let it dry. • Use 120 grit (fine) to sand the surface. • Apply the following coats.
themes
our brands
Top search
French company
Our team is at your disposal on (+33) 4 94 12 03 88 (non-premium rate) Monday to Friday from 8:45 to 12:00am / 1:30 to 5:30pm (4:15pm on friday)
Secure payment
Pay online for your purchases by credit card, immediat transfer, transfer and administrative mandate (ChorusPro).
Delivery and deadlines respected
Benefit from quality, tracked delivery thanks to our partner carriers (UPS, France Express, DPD, Schenker, Geodis, etc.)
The company draws your attention VOUSSERT on the following information: