Caribbean Hotel Hair Dryer

This model is a classic with a flexible cable that avoids the need for an electrical cable, thus ensuring maximum electrical protection.
The Caribbean hotel room hair dryer has a dual AC230V and AC110V shaver socket.
Model with hot air hose.
Adjustable speed and temperature.
Self-protection function via time delay.
Preserve your hair with an airflow that you can fully adjust in terms of heat and blowing power.
It is intended for use in hotel rooms and any professional setting to accommodate the public.
Do not allow use by children without supervision.
White ABS casing for easy maintenance.
Wall mounting using screws at 3 points (bag of screws and wall plugs supplied)
CE certification EMC directive 2014/30/EU and LVD directive 2014/35/EU
This hair dryer being IPX1 it must be installed outside of volume 2 which is detailed in the recommendations for installing hair dryers in a bathroom.

Technical specifications of the Caribbean hair dryer with shaver attachment

Power supply voltage 230 Volts
Frequency 50 - 60 Hz
Electrical protection Class II - IPX1
Connection via a standard electrical outlet or terminal block (by an electrician)
air outlet temperature approximately 65°C
Safety thermostat to limit the maximum drying temperature
Safety timer 10 minutes (maximum drying time)
Nominal frequency 50 Hertz
Rated power 800 Watts
Two shaver sockets, 230 Volts and 110 Volts, equipped with a sliding protective cover
Airflow 54 km/h
2 speeds from 400 watts to 1000 watts
Hose length without extension: 650 mm
Sound level at 2m: 68 dB
Ergonomic handle
Adjustable breathing speed
Automatic disconnection after 5 minutes
Adjustable temperature
Class II electrical insulation
Installation height between 1300 and 1500 mm
Intended for use in hotel rooms or professional settings such as guest houses, campsites, etc.

The plug of this device can only be used for electrical devices with a power of less than 10 Watts.
The device must be installed on a fixed, shock-resistant wall.
Keep away from water and liquid.
Do not have it repaired by an inexperienced person to avoid accidents.
Turn off the power when the device is not in use for a long period of time.
Do not dispose of electrical appliances with unsorted municipal waste; use separate collection facilities for selective sorting.
If electrical appliances are disposed of in landfills or dumps, hazardous substances can seep into groundwater and enter the food chain, harming your health and well-being.
If the power cord is damaged, it must be replaced by an electrician or a person qualified to do so.
This hair dryer must be fixed out of reach of a person taking a bath or shower.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety; children should be supervised to ensure that they do not play with the appliance.

Using the supplied wall plugs and screws, drill three 6mm wide and 35mm deep holes into the wall and insert the wall plugs.
Depending on the support, the dowels may not match and in this case use dowels suitable for the partition.
Then fix the hair dryer mounting plate with screws.
Then attach the hair dryer to the mounting plate.
For optimal use of this hair dryer, we recommend that the drilling position be kept 1.2 m from the floor.

Unhook the handle of the hair dryer which will activate the air blowing
Air speed and temperature can be adjusted using the control switch.
To plug in your razor you have two AC230V and AC110V sockets for both standards.
This device has a self-protection feature. It will automatically shut down after a set period of time. Reset it to restart.