Crystallization powder Taski jontec nobile plus 5 kg

Taski Jontec nobile plus is a high gloss crystallization product for marble floors. Taski Jontec Nobile Plus is used for wet crystallization and protection of limestone floors.
Main properties
• Quickly produces a brilliant shine thanks to the combination of chemical and mechanical actions
• Reduces the penetration of water and dirt, facilitating daily cleaning and maintenance
• Increases the precision of contours and intensifies the natural appearance of the stone
• Significantly increases the anti-slip power of your floors
Benefits
• Formulated for long-lasting, deep crystallization
• Contains fine abrasive components to enhance the action of mechanical polishing
• Very effective and fast action
Technical data
White powder
pH value (pure): N/A
pH in use: < 2
Relative density (20°C): 1 g/ml
The above data is typical of average production and should not be taken as specifications.

1. If the floor has visible scratches, level the surface with a 400 grit diamond disc for 2 minutes per m2 then with an 1800 or 2000 grit diamond disc for 5 minutes per m2 before crystallization.
2. Use a 1% neutral cleaning solution and clean the surface with a monobrush equipped with a red disc , then vacuum the solution. Rinse well with water to remove all dirt particles. Prepare the paste by mixing 3 quarts of Nobile Plus to 1 quart of water. Use 40 grams of paste per m2.
3. Moisten the floor with a damp mop. Make sure the soil is moist but not soaked. It is extremely important that the soil is well moist before applying TASKI Jontec Nobile Plus.
4. Spread the paste in the center of the area to be treated. Place a low-speed monobrush of at least 50kg with a red disk , directly on the dough.
5. Start spreading the paste evenly over the entire area to be treated.
6. Brush with the monobrush for 3-4 minutes per m2. Do not let the paste dry out. Sprinkle lightly with water as needed to keep the paste creamy.
7. At the end of crystallization, dilute the paste with water, vacuum with a wet vacuum cleaner. Generously wet and brush the floor with plenty of neutral cleaning solution to ensure thorough rinsing. Aspirate the solution with a wet vacuum cleaner.
8. After the floor has completely dried, dry buff with a 200-1500 rpm monobrush fitted with a white disc.

Hazard statements:
H302 - Harmful if swallowed.
H315 - Causes skin irritation.
H318 - Causes serious eye damage.