Washable mask Barral gray zig zag by 10

The Barral reusable washable mask is a mask for the general public within the meaning of the Afnor Spec S76-001:2020 patronage -
Category 1 report 2020-04-07-026-50 dated 06/19/2020
This device is neither a medical device within the meaning of EU regulation: 2017/745 (Surgical masks), nor personal protective equipment within the meaning of EU regulation/2016/245 (FFP2 type filter masks).
UNS1: Individual mask for use by professionals in contact with the public. COMPATIBLE
UNS2: Collective purpose mask to protect an entire group wearing these masks. COMPATIBLE

Mask WITHOUT nose clip
Separate mesh mask washing

Attention:
As of June 19, the Directorate General of Armaments (DGA) no longer accepts new files (See Communication DGA).
Testing of masks, including washes, must be carried out by a competent third party.
Such testing capabilities are listed, in alphabetical order:
at CEA LITEN
at CERTAM
with CETELOR (washing only)
at the French Institute of Textiles and Clothing (IFTH) ;
within the University of Haute Alsace in Mulhouse by taking information from the Pôle Textile Alsace (PTA);

Validated at 30 washes by tests report 20200622-P03-C000030-2X EVO 40G-1FIN-Complete test (1) according to DGA protocol
Performance level:
- Material whose performance has been measured by the Université Haute Alsace laboratories after 30 washes
- filtration efficiency of 3 µm particles > 99.9%
- air permeability for a depression of 100 Pa = 117 Lm-2.s-1

Washing the masks separately (do not mix with the rest of the laundry) to avoid breaking the straps.
Highly recommended washing in a separate laundry net.
To be ordered separately reference 8878064 or 888468

This makes for a reduced cost of use compared to a disposable mask whose use is unique.
This mask is intended to reduce the risk factor of transmission of infectious agents (Virus, Flu, COVID-19,...).
Its port makes it possible to constitute a protective barrier against possible viral penetration in the mouth and nose area of its user or of a person in the vicinity.

Technical specificity of the mask:
- Evolon® EVO 40PK double layer textile
Microfilament fabrics 70% - Polyethylene Terephthalate and 30% Polyamide
- Polyethylene Terephthalate and 30% Polyamide
- Spunbond hydro bonded
- Fasteners: polyester

General public mask Made in France according to Afnor Spec S76-00 patronage, tested by IFTH laboratories according to the DGA protocol, its permeability is 117L.m-².S-1 for a depression of 100Pa (standard >96L. m-².S-1) and its filtration efficiency is 99.9% of 3µm particles emitted (standard >90%).

Area of use: This device is neither a medical device within the meaning of Regulation EU/2017/745 (Surgical masks), nor a
personal protective equipment within the meaning of Regulation EU/2016/425 (FFP2 type filter masks).
The design of this mask was established following the patronage recommendations of AFNOR SPEC S76-001 and tested on a wearer for 4 hours by us.
This mask is intended for the professional environment and is exclusively reserved for non-sanitary uses.
It is intended to prevent the projection of droplets.

This individual mask is intended to be offered to professionals who have to meet a large number of people during
of their activities (cash hostesses, law enforcement officers).

This device is not intended for use by healthcare personnel in contact with patients.
FFP2 type filtering masks and masks for medical (or surgical) use are intended to be used and reserved for healthcare personnel. The wearing time will be less and limited to 4 hours on a single day (equivalent to half a day).
The mask makes it possible to form a protective barrier against possible viral penetration into the mouth and nose area of its user or of a person in the vicinity.
Its purpose is to protect this area against any contact with the hands.
Only limited protection is claimed.
It is recommended to clean the mask before use.
The barrier mask is sized to correspond to the average morphology of the French population.

The efficiency parameter sought is the filtration capacity of the materials used for particles with a diameter of 3 microns emitted by the wearer.
This device is not intended for use by healthcare personnel in contact with patients.
Filtration efficiency greater than 90%.
Like any consumer mask, wearing time is limited to 4 hours.

Logistics
Retail packaging pocket bag of 10 - Standard packaging

(1) The test validates the resistance and ability of the filter media to retain all of its filtering and resistance properties. It does not take into account the attachments of the masks (thongs, elastics, etc.)

Price indicated per pack of 10