Taski Jontec Jonclean 800 floor degreaser for automatic scrubber dryers 20L

The solution for parking lot, garage, and industrial floors. Usable with a single-disc scrubber, automatic scrubber, manually, or high-pressure cleaner. Powerful degreasing and descaling action. For professional use when restoring unprotected floors.
Taski Jontec Jonclean 800 Diversey. Powerful alkaline degreaser and descaling agent. For floor scrubbers and pressure washers. Removes tire marks, grease and mineral oils, and tar stains.
Alkaline degreasing detergent specifically formulated for degreasing and for occasional restoration operations on unprotected floors.

Advantages of Taski Jontec jonclean 800

• Enhanced anti-greying properties on tiles
• Versatile: suitable for manual and mechanized use ( floor scrubber and low/high pressure washer )
• Ideal for industrial cleaning and floor restoration, such as for parking lots
• Removes heavy soiling (tire marks, grease and mineral oils, tar marks, etc.) from all surfaces (e.g., concrete, painted concrete, steel, painted surfaces, enamel, tiles, plastic)

Technical specifications

Technical data
Appearance: Clear, red liquid
pH value (pure): > 13.2
pH value (during use): 11.5
Relative density (20°C): 1.08 g/cm³
The above data is characteristic of average production and should not be taken as specifications.

Sold in 20-liter containers
Available in 5-litre cans and 200-litre drums.

Manual :
Dosage: concentration of 3 to 5%
Automatic floor scrubber, high-pressure cleaner.
- Low Pressure Cleaner (pre-stain removal): concentration of 5 to 10%
- High-pressure cleaner (direct application): concentration of 1 to 3%
- Floor scrubber: concentration of 2 to 3%
Application:
1. Pre-spraying at low pressure: spray the product onto the surface to be cleaned. Leave for 5 to 10 minutes depending on the level of soiling of the floor.
Rinse the surface with high pressure using cold or hot water (60/70°C).
2. Direct application under high pressure (80/100 bars), in cold or hot water: apply the solution directly onto the surface to be cleaned.
3. Floor scrubber: Add the product to the water tank of a floor scrubber and apply the solution. Run the floor scrubber over the area to be treated and remove any residual water.
4. Use the indirect method for stubborn dirt: rub the surface to be cleaned without vacuuming, leave for 10 minutes, then rub a second time and vacuum up the residual water directly.
Important :
Do not use on soils sensitive to water and alkali.
In case of splashes, wipe immediately with a damp cloth.
Before use, test the compatibility of the materials on a small, inconspicuous area.